Laptop Cooler Fan Cleaning: If you start to notice that the laptop began to slow down, longer processing requests, open programs, and files, and quickly and strongly heats up, the reason is probably the excessive accumulation of dust. TickTockTech is a computer repair company in Calgary, Alberta. The company provides tech support services which include: computer repair, laptop repair, technical support, or IT services. They also provide Same-day service and Free onsite estimates. You don’t have to have special skills to remove dust. By following the advice and instructions for cleaning the cooler on Acer laptops, you can perform this task yourself.
In addition, you should not wait until the moment when problems with the device become apparent, it is recommended to clean the inside of the laptop and its fan once a year, or at least visually determine whether the visible part of the radiator and other laptop ventilation holes are clogged with dust. If your laptops fan is not functioning, you should replace it because your laptop will not be able to cool itself when you work, especially with heavy gaming. The laptop will start to overheat and shut down. You can therefore check the coolers at sites such as these: Zeto.ua, and Amazon.com. On the first site will be available to search for a laptop fan by device model.
Tools Required to Clean Laptop Cooler
In general, the procedure does not involve anything complicated, but you need to be prepared for it. When you decide for yourself that you can handle all the work yourself, you can move on to collecting the necessary tools.
To disassemble your laptop, you will need a screwdriver (Phillips-head and flat-tip) and tweezers. A small hoover is required to clean the keyboard. An electronic disassembly kit will not be superfluous. It can be found at hardware shops and on the Internet. Wipes and cotton pads are also required.
Instead of a hoover, you can use a regular hair dryer with a power of 1800W or more, but only with cold air! You’ll also need a dusting brush or toothbrush, a good light and a smartphone camera to take a picture of how everything was originally wired.
Preparing for cleaning
A cosmetic cleaning will first be required. Before dismantling the laptop, vacuum the outside of it, paying particular attention to the keyboard. A compact USB hoover is best for this. If this is not available, a normal hoover with a narrow nozzle is sufficient, but the power should be kept to a minimum.
In some cases, it is possible to clean the laptop without disassembly. This is possible if your ACER model has well ventilated heatsink ribs (on the side) and other openings. However you can’t clean the fan itself.
Disassembly and Cleaning of the laptop
How to clean the cooler without damaging it? In order to do this, the sequence of steps is as follows:
Disassemble the housing
Turn the notebook upside down with the bottom lid facing upwards. Then remove the battery and remove the cover, secured with screws. All visible nuts must be unscrewed, after which the plug connections are removed. Then turn the notebook upside down, open the cover and carefully remove the keyboard. If the keyboard will sit firmly, you can pry it with something thin, e.g. a plastic card. When the keypad is lifted slightly, you need to pull the cable out of the plug and then pull it completely out.
Opening the enclosure
Use the card to pry open the top section of the housing all around the perimeter. All catches must be open. Remove the flat cable from the connector.
Removing the motherboard
As the cooler is located on the inside of the ACER motherboard, it also needs to be removed. To do this, you need to unscrew all the nuts, remove the plugs that are connected to the USB ports and the screen. Then you must disconnect CPU cooler.
Now you can finally move on to the final step. The cooler is cleaned using a mini-vacuum cleaner. To make sure you have removed all the dust, you can run your finger over the cooler – it should spin easily. If it is difficult to turn, it is likely that dust has accumulated under the impeller. To remove it, remove the protective cover from the cooler. After that you need to vacuum the remaining components of the laptop and then you can move on to its assembly.
Lubricating the Cooler
Take your time when putting everything back together. Now that you have got the cooler, remove the impeller (blades), clean the inside with a cotton swab and put a drop of machine oil in the middle. A special silicone oil or thick car gear oil is better.
Also Check: How to Choose the Best Translation Service?
This is how you can easily clean your laptop cooler. Hope the above guide will help you to clean your laptop cooler easily without any dificulties. If you have any queries related to the above laptop cooler cleaning guide please feel free to ask us in the below comment section. Thanks for your site.
Tags: how to clean laptop cooler fan without opening, how to clean laptop fan at home, laptop cooler fan cleaner software, how to clean laptop fan without compressed air, how to clean laptop fan, how to clean laptop fan lenovo, how to clean laptop fan with vacuum, laptop cooler fan cleaning kit.